Ultimaker 2 3D Drucker: Difference between revisions

From KIP Wiki
ā§¼kip-jumptonavigationā§½ā§¼kip-jumptosearchā§½
m (Dorn moved page 3ddrucker um2 to Ultimaker 2 3D Drucker)
No edit summary
Ā 
(7 intermediate revisions by the same user not shown)
Line 1: Line 1:
== Infos über den UM2 3D Drucker ==
== Infos about the UM2 3D Printer ==

=General Settings=
The glass build plate should be clean before printing, e.g. no fingerprints, dust, ā€¦
Cleaning with water and soap and drying afterwards is sufficient.

The build plate has to be leveled. Leveling can be done via the printer menu guide.

The first layer is the most important. If it does not stick to the print bed, the print will most certainly fail. A heated print bed and low first layer speed (around 10 mm/s) contribute to better sticking of the material to the build plate.

The print speed after the first layer not only depends on the material, but also on the nozzle temperature, layer hight and nozzle diameter. Speeds up to 40 mm/s were tested with good results.

Overhangs are possible up to an angle of 50Ā° depending on the used material.

=Materials=
For the standard slicer Cura, the Printer settings can be imported. Follow Settings/Profiles/Manage_Profiles/ to import Cura profiles.
(todo: upload guidelines)

*PLA
*PETG
*ABS:
[[File:ABS guide.tar.gz|thumb|ABS_guide]]
*TPU (flexible)


=3D models=
These material specific settings are just guidlines. Each model has to be set up individually.
Common problems can be found here: https://www.simplify3d.com/support/print-quality-troubleshooting/

Latest revision as of 16:31, 31 October 2019

Infos about the UM2 3D Printer

General Settings

The glass build plate should be clean before printing, e.g. no fingerprints, dust, ā€¦ Cleaning with water and soap and drying afterwards is sufficient.

The build plate has to be leveled. Leveling can be done via the printer menu guide.

The first layer is the most important. If it does not stick to the print bed, the print will most certainly fail. A heated print bed and low first layer speed (around 10 mm/s) contribute to better sticking of the material to the build plate.

The print speed after the first layer not only depends on the material, but also on the nozzle temperature, layer hight and nozzle diameter. Speeds up to 40 mm/s were tested with good results.

Overhangs are possible up to an angle of 50Ā° depending on the used material.

Materials

For the standard slicer Cura, the Printer settings can be imported. Follow Settings/Profiles/Manage_Profiles/ to import Cura profiles. (todo: upload guidelines)

  • PLA
  • PETG
  • ABS:

File:ABS guide.tar.gz

  • TPU (flexible)


3D models

These material specific settings are just guidlines. Each model has to be set up individually.

Common problems can be found here: https://www.simplify3d.com/support/print-quality-troubleshooting/