User:Bkaplan

HCS Test to remember / to do

• after adjustNumInputs: distribute n_e, n_i equally over 4 64-SynDriver blocks
• Denke mol drüwwer nach: g_stim / g_bash
• JBill: HW: V_reset auf V_rest setzen, um Resonanz-Peak Verschiebung abzumildern

Setup files

before compiling: . ~/project/misc/set_build_env files to compile:

• /project/fpgasystem/sw/make
• /project/pynnHardware/src/hardware/make

on evolver12 take care that pythonversion=2.4

current bitfiles for nathan boards can be found here [[1]]

Configure evolver13

• config_darkwing ~/project/facets/bitfiles/darkwing_2007-11-16.bit
• dwserver
• dinit -r
• config_nathan ~/project/facets/bitfiles/nathan_top_newtempsense_2008-01-29.bit
• killall dwserver
• dwserver
• dinit -r
• duse -all

old stuff

• start dwserver
• bkaplan@evolver13:~/bitfiles/evolver13$ config_darkwing -u 1 ~/bitfiles/darkwing.bit 40
• bkaplan@evolver13:~/bitfiles/evolver13$ config_nathan nathan_top_spikey_ext_clk2_fastsdram.bit 2
• bkaplan@evolver13:~/bitfiles/evolver13$ config_darkwing darkwing.bit 60
• bkaplan@evolver13:~/bitfiles/evolver13$ screen dwserver
• bkaplan@evolver13:~/bitfiles/evolver13$ dinit -r

Configure evolver12

Works for old backplane only !!!

• do NOT start dwserver, or terminate running dwserver respectively
• bkaplan@evolver12:~/bitfiles/evolver12$ config_darkwing -D 11 -u 1 darkwing_sctrl_nachurlaub.bit
• bkaplan@evolver12:~/bitfiles/evolver12$ config_nathan -D 11 nathan_top_spikey_ana_clk1_fastsdram.bit 2
• bkaplan@evolver12:~/bitfiles/evolver12$ dwserver
• bkaplan@evolver12:~/bitfiles/evolver12$ dinit -r