STILL: Difference between revisions
From KIP Wiki
ā§¼kip-jumptonavigationā§½ā§¼kip-jumptosearchā§½
| Line 9: | Line 9: | ||
* The heater is connected with BOX II X3:(1-4). |
* The heater is connected with BOX II X3:(1-4). |
||
* R<sub>Still</sub>= 1.13 k{{O}}, new heater installed November 2011. |
|||
* I<sub>Still</sub>= 3-5 mA, depending on required cooling power. |
* I<sub>Still</sub>= 3-5 mA, depending on required cooling power. |
||
* The still heater is mounted on the lower side of the still. It's wires lead from the resistor via a fed-through at the flange of the still to the 1K-pot and are shielded by a textile tube. |
* The still heater is mounted on the lower side of the still. It's wires lead from the resistor via a fed-through at the flange of the still to the 1K-pot and are shielded by a textile tube. |
||
<gallery widths="120" heights="160" perrow="3"> |
|||
Image:Still_heater_01.jpg|Still heater |
|||
Image:Still_heater_02.jpg|Wiring |
|||
Image:Still_heater_03.jpg|Wiring |
|||
</gallery> |
|||
{{clear}} |
{{clear}} |
||
Revision as of 11:01, 3 January 2012
STILL
Here are some technical details about the still.
- Volume: VStill=??? .
Still Heater
- The heater is connected with BOX II X3:(1-4).
- RStill= 1.13 k, new heater installed November 2011.
- IStill= 3-5 mA, depending on required cooling power.
- The still heater is mounted on the lower side of the still. It's wires lead from the resistor via a fed-through at the flange of the still to the 1K-pot and are shielded by a textile tube.
Still heater
Wiring
Wiring
Old Still Heater
- Resistance of still heater : RStill=880. Based on the original SHE-manual it was supposed to be ~1k?
! removed November 2011, since it didn't work anymore. One resistance-foil was broken.
