Ultimaker 2 3D Drucker: Difference between revisions
No edit summary |
No edit summary Ā |
||
| (5 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
== Infos |
== Infos about the UM2 3D Printer == |
||
=General Settings= |
=General Settings= |
||
| Line 9: | Line 9: | ||
The first layer is the most important. If it does not stick to the print bed, the print will most certainly fail. A heated print bed and low first layer speed (around 10 mm/s) contribute to better sticking of the material to the build plate. |
The first layer is the most important. If it does not stick to the print bed, the print will most certainly fail. A heated print bed and low first layer speed (around 10 mm/s) contribute to better sticking of the material to the build plate. |
||
The print speed after the first layer not only depends on the material, but also on the nozzle temperature. |
The print speed after the first layer not only depends on the material, but also on the nozzle temperature, layer hight and nozzle diameter. Speeds up to 40 mm/s were tested with good results. |
||
| ⚫ | |||
=Materials= |
=Materials= |
||
For the standard slicer Cura, the Printer settings can be imported. Follow Settings/Profiles/Manage_Profiles/ to import Cura profiles. |
For the standard slicer Cura, the Printer settings can be imported. Follow Settings/Profiles/Manage_Profiles/ to import Cura profiles. |
||
(todo: upload guidelines) |
|||
*PLA |
*PLA |
||
*PETG |
*PETG |
||
*ABS |
*ABS: |
||
[[File:ABS guide.tar.gz|thumb|ABS_guide]] |
|||
*TPU (flexible) |
*TPU (flexible) |
||
| Line 22: | Line 26: | ||
=3D models= |
=3D models= |
||
These material specific settings are just guidlines. Each model has to be set up individually. |
These material specific settings are just guidlines. Each model has to be set up individually. |
||
| ⚫ | |||
Common problems can be found here: https://www.simplify3d.com/support/print-quality-troubleshooting/ |
Common problems can be found here: https://www.simplify3d.com/support/print-quality-troubleshooting/ |
||
Latest revision as of 16:31, 31 October 2019
Infos about the UM2 3D Printer
General Settings
The glass build plate should be clean before printing, e.g. no fingerprints, dust, ā¦ Cleaning with water and soap and drying afterwards is sufficient.
The build plate has to be leveled. Leveling can be done via the printer menu guide.
The first layer is the most important. If it does not stick to the print bed, the print will most certainly fail. A heated print bed and low first layer speed (around 10 mm/s) contribute to better sticking of the material to the build plate.
The print speed after the first layer not only depends on the material, but also on the nozzle temperature, layer hight and nozzle diameter. Speeds up to 40 mm/s were tested with good results.
Overhangs are possible up to an angle of 50Ā° depending on the used material.
Materials
For the standard slicer Cura, the Printer settings can be imported. Follow Settings/Profiles/Manage_Profiles/ to import Cura profiles. (todo: upload guidelines)
- PLA
- PETG
- ABS:
- TPU (flexible)
3D models
These material specific settings are just guidlines. Each model has to be set up individually.
Common problems can be found here: https://www.simplify3d.com/support/print-quality-troubleshooting/
